Chipset brings power-over-Ethernet to connectivity applications

ST’s new PoE chipset also targets smart-building and smart-office applications such as IP cameras, access-control systems, display panels, lighting, curtain or shutter controllers, video-call systems, IP phones, and tabletop consoles.

The PM8804 implements a complete PWM controller for a 48V isolated flyback or forward converter, including dual low side gate drivers for high efficiency forward active-clamp topologies.

The operating frequency is selectable up to 1MHz, allowing the use of small external filter and decoupling components for high power density. Also featuring a high voltage start up regulator with 20mA output capability, the PM8804 helps save on board space and bill of materials.

The PM8805 companion chip contains two active bridges, a charge pump for driving high side MOSFETs, a hot-swap FET, and the IEEE 802.3bt compliant interface. Integrating the active bridges saves the real-estate otherwise occupied by eight discrete MOSFETs and their driving circuitry.

The PM8805 generates a Power-good signal for enabling the PM8804 and other circuitry such as an LED driver, and supports Maintain Power Signature (MPS) current control that allows the PD to enter power-saving standby without being disconnected.

Both devices are in production now. The PM8804 is packaged as a 3x3mm, 0.5mm-pitch VFQFPN-16, and priced at $0.60 for orders of 1,000 pieces. The PM8805 in 8x8mm thermally enhanced VFQFPN-43 featuring exposed pads is $4.50.