Power Management
TPS40210QDGQRQ1
Texas Instruments
TPS40210QDGQRQ1 Inventory
by: Texas Instruments
Parameters
Features
Products to complete your design
LDO Regulator Pos 1.275V to 28V 0.05A 8-Pin HTSSOP EP T/R
LM5060-Q1 High-Side Protection Controller with Low Quiescent Current
LDO Regulator Pos 1.5V to 40V 0.3A 8-Pin SO PowerPAD T/R
The TLC555-Q1 is a monolithic timing circuit fabricated using the TI LinCMOS™ process. The timer is fully compatible with CMOS, TTL, and MOS logic and operates at frequencies up to 2 MHz. Because of its high input impedance, this device uses smaller timing capacitors than those used by the NE555. As a result, more accurate time delays and oscillations are possible. Power consumption is low across the full range of power-supply voltage.
Like the NE555, the TLC555-Q1 has a trigger level equal to approximately one-third of the supply voltage and a threshold level equal to approximately two-thirds of the supply voltage. These levels can be altered by use of the control voltage terminal (CONT).
When the trigger input (TRIG) falling below the trigger level sets the flip-flop, and the output goes high. Having TRIG above the trigger level and the threshold input (THRES) above the threshold level resets the flip-flop, and the output is low. The reset input (RESET) can override all other inputs, and a possible use is to initiate a new timing cycle. RESET going low resets the flip-flop, and the output is low. Whenever the output is low, a low-impedance path exists between the discharge terminal (DISCH) and GND. Tie all unused inputs to an appropriate logic level to prevent false triggering.
The advantage of the TLC555-Q1 is that it exhibits greatly reduced supply-current spikes during output transitions. Although the CMOS output is capable of sinking over 100 mA and sourcing over 10 mA, the main reason the TLC555-Q1 is able to have low current spikes is due to its edge rates. This minimizes the need for the large decoupling capacitors required by the NE555.
The TLC555-Q1 is characterized for operation over the full automotive temperature range of –40°C to 125°C.
LM5060-Q1 High-Side Protection Controller with Low Quiescent Current
TPS62133A-Q1 3V - 17V 3A AUTOMOTIVE Step-Down Converter In 3X3 QFN Package
Processor Supervisor 2.93V 0V to 5.8V 5-Pin SOT-23 T/R
Temp Sensor Digital Serial (2-Wire, I2C) 6-Pin SOT-563 T/R
Automotive 2V-Input, Reinforced Isolated Amplifier With High CMTI for Voltage Sensing 8-SOIC -40 to 125
