Passives

Battery Charger front-end IC increases system safety when charging a cell phone

5th September 2007
ES Admin
0

Texas Instruments has introduced today a family of battery charger front-end integrated circuits, which dramatically increases protection when charging a cell phone or other portable electronic device. The 2 mm x 2 mm safety circuits protect a system from input over-voltage, over-current and battery over-voltage conditions, which may result from a power spike during charging, or a defective or incorrect wall adapter.

Adding power protection to a handheld device helps safeguard end users against accidental fault conditions, which reduces the number of customer end-equipment returns, said Masoud Beheshti, director of TI's battery charge management business. This unique charger front-end circuit provides three solid levels of protection to provide the maximum amount of safety when charging a handheld device.

The first member of TI's new bq243xx family of charger front-end circuits with integrated FETs, the bq24314, adds extra protection to a lithium battery when a charger circuit fails due to a fault condition.
The protection IC can report status of the fault to the host processor, such as TI's new DM355 processor based on DaVinciT technology (see: www.ti.com/dm355pr) or an application processor from the OMAPT 3 product family, allowing the host processor to apply additional corrective actions.

Input over-voltage conditions are caused by steady-state or transient voltage events, such as hot-plugging a charged adapter; using a non-regulated or incorrect adapter; or load transients. Any of these events can increase or spike the voltage applied to the device and potentially damage the host system. The bq24314 detects the over-voltage level and effectively disconnects the input to the charger to protect the device. The device features an input over-voltage threshold of 5.85
V. Another version of the circuit, the bq24316, supports up to 6.8 V.

Input over-current conditions can occur in integrated power management devices that incorporate a battery charger, which have a direct connection from the input to the system's bus voltage. Often there is no protection from pulling excessive current from the adapter to the system. The programmable bq24314 limits the input current by sensing and regulating its integrated MOSFET to ensure the system does not pull an excessive amount of current.

Potential hazardous events may occur if single-cell, Li-Ion and Li-Polymer batteries are over-charged beyond their float voltage -- typically around 4.2 V. Because of this, portable designers currently
seek redundant safety measures to ensure battery safety and compliance. The bq24314 offers a second level of protection that helps monitor the battery's voltage, and if an over-voltage is detected, interrupts the input charging source.

The bq24314 and bq24316 are available today in volume from TI and its authorized distributors. Both devices come in a tiny 8-pin, 2 mm x 2 mm small-outline, no-lead (SON) package. Suggested retail pricing for both in 1,000-piece quantities is $0.75. Evaluation modules of the bq24314
and bq24316, design application notes and TI's easy-to-use online power management selection tool are available through power.ti.com.

Featured products

Product Spotlight

Upcoming Events

View all events
Newsletter
Latest global electronics news
© Copyright 2024 Electronic Specifier