Optoelectronics

Advanced sensor technology marks pixel structure evolution

10th November 2015
Nat Bowers
0

Advancing its portfolio of innovative pixel technologies, OmniVision Technologies has announced PureCel Plus and PureCel Plus-S. Utilising a Buried Colour Filter Array (BCFA) and Deep Trench Isolation (DTI) technology, PureCel Plus and PureCel Plus-S sensors deliver best-in-class pixel performance with significant improvements in low-light performance and crosstalk reduction.

One of the key benefits of PureCel Plus technology is the reduction of pixel crosstalk, which minimises colour crosstalk and colour noise, dramatically improving colour reproduction under low-light conditions. Another critical benefit is the angular response of the sensor. With PureCel Plus technology, OmniVision’s sensors can provide higher signal response at a larger incident light angle than the one with predecessor technologies. This technology greatly increases the tolerance of new camera systems to incident light angles. As a result, with PureCel Plus sensors, module design houses can use brighter lenses and build camera systems with much thinner geometries.

In addition to PureCel Plus, PureCel Plus-S leverages OmniVision’s stacked die technology, which separates the imaging sensor array from the image sensor processing pipeline. This configuration supports additional system functionality and improves sensor performance, while enabling a much smaller footprint when compared with non-stacked sensors. As a result, sensors built with PureCel Plus-S technology can deliver best-in-class image quality and high functionality with minimal chip size.

Dr. Song Xue, Senior Manager, Sensor Technology, OmniVision, commented: “It has long been an industry-wide presumption that increasing resolution by reducing pixel size may result in the degradation of camera performance, due to low-light sensitivity. However, as we are seeing with PureCel Plus, that is not always the case. Our new 1.0μm sensors built on PureCel Plus technology will exhibit the same level of signal-to-noise ratio as 1.12μm sensors built on our previous generation technologies. Today’s advancement enables us to continue reducing pixel size while maintaining the highest image and video quality standards.”

Featured products

Upcoming Events

View all events
Newsletter
Latest global electronics news
© Copyright 2024 Electronic Specifier