Switchtec's timers for complex control and space saving applications

Panel builders, equipment manufacturers, H&V applications and system designers are all looking to create smaller, more compact, more 'intelligent' control panels, and will benefit from the Anly timers' compact design.



Exhibiting versatility, the DIN mounting, Anly H3D-M timer from Switchtec has no less than seven output modes. These are, on delay, on pulse, delay off (trailing edge, signal start), off pulse (trailing edge, signal start), on pulse (leading edge, signal start), cyclic pause start, and cyclic pulse start.



Again showing tremendous flexibility and versatility, the H3D-M timer operates from a wide supply voltage of 12 - 240V DC or AC 50/60Hz, and the operating voltage range is from 90 - 110% of rated voltage. Similarly, the timer can be programmed to operate from as low as 1 second up to a maximum time of 100 hours. The H3D-M has a single pole change over contact rated at 8A 250VAC/30VDC. Power consumption for the timer is 1.9VA.



The timer's faceplate has two LEDs, one to indicate power on/off (this LED flashes when timing), and one to show output relay status. Three screw controls are for range, time and mode selection. To simplify setting up, a user manual with an easy to follow timing chart is provided with the unit.



An ambient temperature range of -10 to 50 degrees C is tolerated, the maximum humidity figure is 85%, and the weight of the timer is just 62g. The H3D-M is 17.5mm wide, and due to its clever design and construction its height and depth are only 71.2mm and 60mm respectively. It is both CE Approved and RoHS Compliant.



Easy to install and set up, the HD3-M has been designed to be as compact as possible without compromising on its interface with the installer. Timers can be small but they have to remain practical, versatile and easy to use. The Anly H3D-M from Switchtec meets these criteria.