TPA2011D1YFFR

TSC2004 12-Bit, Nanopower, 4-Wire Touch Screen Controller

Power Switch 0.5A 4-Pin DSBGA T/R

Conv DC-DC Single Step Down 2.3V to 4.8V 8-Pin uSIP T/R

Conv DC-DC Single Step Up 2.3V to 5.5V 6-Pin WSON EP T/R

LDO Regulator Pos 3.3V 0.2A 4-Pin X2SON T/R

Analog Switch Single DPDT 10-Pin UQFN T/R

Circuit Protection Misc Over Voltage Protection

PoE Interface and Isolated Converter Controller 14-Pin TSSOP T/R

TPS61240 5V, 400mA, 4MHz Step-Up DC/DC Converter

The TS3USB3000 device is a double-pole, double throw (DPDT) multiplexer that includes a high-speed Mobile High-Definition Link (MHL) switch and an USB 2.0 High-Speed (480 Mbps) switch in the same package. These configurations allow the system designer to use a common USB or Mico-USB connector for both MHL video signals and USB data.

The TS3USB3000 has a V_CC range of 2.7 V to 4.3 V and supports overvoltage tolerance (OVT) feature, which allows the I/O pins to withstand overvoltage conditions (up to 5.5 V). The power-off protection feature forces all I/O pins to be in high-impedance mode when power is not present, allowing full isolation of the signal lines under such condition without excessive leakage current. The select pins of TS3USB3000 are compatible with 1.8-V control voltage, allowing them to be directly interfaced with the General-Purpose I/O (GPIO) from a mobile processor.

The TS3USB3000 comes with a small 10-pin UQFN package with only 2.0 mm × 1.5 mm is size, which makes it a perfect candidate to be used in mobile applications.