End-to-end tester targets V2X applications

1st October 2015

Mick Elliott

0 0

Datasheet

The V2X end-to-end tester for vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I) applications is based on the fully automated R&S TS-ITS100 RF conformance test system from Rohde & Schwarz. The RF conformance test system is augmented by the Vector CANoe application and communications test system, which monitors radio communications and internal vehicle buses and even simulates some of them.

The Commsignia ITS-OB2-M onboard unit for 802.11p serves as the DUT. The overall system is the first to enable automotive manufacturers and their suppliers to verify the functionality and performance of vehicle-to-vehicle applications with an end-to-end test – from transmitting RF signals over a simulated channel to receiving the RF signal via an onboard unit and subsequent presentation on an in vehicle display.

During the demonstration, an 802.11p message "Warning, vehicle braking" is transmitted via an RF signal. The R&S TS-ITS100 generates an 802.11p RF signal with the required content and transmits it to the Commsignia onboard unit.

The Rohde & Schwarz system uses fading to impair the signal and simulate real-world propagation conditions. The ITS-OB2-M receives the RF signal, converts the message to CAN bus format and feeds it to the vehicle bus monitored by the CANoe system.

CANoe verifies whether the RF signal was correctly transmitted from the onboard unit to the CAN bus despite fading. The message is then forwarded to an in vehicle display simulated by the CANoe system.

The joint 802.11p test demonstrator from Rohde & Schwarz, Vector and Commsignia will be on display at the ITS World Congress in Bordeaux (October 5-9) at the Rohde & Schwarz booth